The storage method of filament geotextile is as important as the method of use. I hope everyone will not ignore it. Only storing the fine-textile 3D geonet factory price in the correct way can ensure that its performance is not affected and there are no problems in use. So how should we store the filament geotextile correctly? The filament geotextile should be protected from damage before installation. The filament geotextile should be stacked in a place where there is no water accumulation, the height of the pile should not exceed four rolls, and the identification piece of the roll can be seen. The filament geotextile must be covered with an opaque material to prevent UV aging. During the storage process, the integrity of the label and the integrity of the data should be maintained. Protect filament geotextiles from damage during transportation (including from material storage to on-site transportation). The physically damaged filament is repaired. Do not use severely worn filament geotextiles. Any filament high quality plastic geonet in contact with leaking chemical reagents is not allowed to be used in the project. When applying filament geotextiles, use the buried type as much as possible, and the thickness of the cover layer or other materials should not be less than 30-40 cm, as thick as possible, so as to be able to exert the corresponding effect. In addition, it cannot be used alone in anti-seepage water systems. Should be used in combination with impermeable layer, protective layer and other products to achieve better results. If it is impossible to achieve the intended purpose alone, then the product itself is. This is something everyone needs to pay attention to in advance and cooperate with other system materials as much as possible. Secondly, the filament geotextile needs to select some construction sites where the soil is relatively strong, as even as possible when laying. Otherwise, it is easy to appear or break in a certain part, which greatly reduces the practicality of the product. And, when in contact with other films, it should be used as a protective layer. Then, during the concrete laying process, the filament HDPE geonet manufacturers will not be too tight. Suitable to relax a bit. It is more suitable for a little ripple. Otherwise, due to the relatively large thickness of the soil layer above, it is easily torn. Once the degree of occurrence is not good, it will be damaged, so it is said that the paving is as loose as possible, which can give the filament geotextile a certain degree of flexibility. When using the product, do not let the stone be pressed on it, otherwise it will easily damage the filament geotextile. Thereby reducing the effect of geotextiles. These are the methods to properly store filament geotextiles, as well as some considerations when using filament geotextiles. I hope everyone will pay attention to them when using and storing.